synced with pro tools- see signal, but can\'t hear signal- HELP!!!!

synced with pro tools- see signal, but can\'t hear signal- HELP!!!! 

I have synced to pro tools, and have made the mpc the master, oo1 slave. I also have the audio of the mpc going to tracks 3/4 of 001. When record enabled I see the signal on tracks 3and 4 but hear nothing, as well as no audio waveform shows on the screen, but I see the SIGNAL! What is the problem?

Re: synced with pro tools- see signal, but can\'t hear signal- HELP!!!! 

maybe you actually have to start recording 1. set up a channel to record to (audio-channel, not aux-channel...) 2. route an input to that channel 3. record enable the channel (little "rec" rectange above the fader.) 4. hit the record-button in the transport-section 5. hit the play-button in the transport-section (or skip step 4+5 and press 3 on the numerical keyboard with num-lock switched on...) now you are recording.... To listen to what you do, you ether have to connect a headphone to the digi001, or connect your amplifier or powered monitors to the "monitor out" on the back of the break-out box. The monitor-button on the front of the box should be depressed! All this is perfectly written down in the getting started guide...